PRODUCTS
HUWA Z-Combi Alignment Saddle
Characteristics of the HUWA ZC saddle:
- Solid, well thought-out construction.
- High quality GGG 50 ductile iron.
- Produced according to DIN 3543, Part 1.
- Saddle is provided with epoxy coating, EWS epoxy according GSK-diridives RAL-G2-662 DVGWW-270, which prevents rust.
- DVGW (G87 e 087) approved.
- Perfect seal through flat O-ring, which is enclosed in the chamber of the alignment saddle (see illustration). Through a special combination of Oring and flat ring, a two-fold seal is obtained.
- Rubber for ring gasket is NBR.
- Applicable for various types of material, such as asbestos-cement, cast iron and steel.
- Very suitable for pipes covered with polyethylene. When the HUWA ZC Saddle is placed, the polyethylene layer does not have to be removed.
- Test report upon request.
- Wide, 100% stainless steel lower bracket.
- Lower bracket provided with a special rubber band.
- Stainless steel, electrolytic zinc plated nuts, to prevent fretting.
- Saddles available from DN 40 up to including DN 600.
- Suitable for alignments under pressure.
Dimensions of the HUWA ZC Saddle:
- The HUWA ZC Saddle can be supplied with a tapped service outlet of 1/2” up to and including 2”.
- Special service outlets are available upon request.
- The HUWA ZC Saddle can be supplied from DN 40 up to and including DN 600.
- Strap width 60 mm
- Also available with branch according to Polva 1 1/2” to 2”.